Mercedes-Benz E-Class: Tire pressure of 180 kPa (1.8 bar/ 
26 psi) is reached - TIREFIT kit - Flat tire - Breakdown assistance - Mercedes-Benz E-Class Owners ManualMercedes-Benz E-Class: Tire pressure of 180 kPa (1.8 bar/ 26 psi) is reached

•► Press the on/off switch on the tire inflation compressor to 0.

The tire inflation compressor is switched off.

•► Unscrew the filler hose from the valve of the faulty tire.

After use, excess TIREFIT may run out of the filler hose. This could cause stains.

Therefore, place the filler hose in the plastic bag which contained the TIREFIT kit.

•► Stow the tire sealant bottle and the tire inflation compressor.

•► Pull away immediately.

WARNING
Do not exceed a vehicle speed of 50 mph (80 km/h). A TIREFIT repair is not designed to operate at higher speeds.

The sticker must be attached on the instrument cluster where it will be easily seen by the driver.

Vehicle handling characteristics of a TIREFIT repaired tire may change. Adapt your driving accordingly.

•► Stop after driving for approximately ten minutes and check the tire pressure with the tire inflation compressor.

WARNING
If tire inflation pressure has fallen below 130 kPa (1.3 bar/26 psi) do not continue to drive the vehicle.

Park your vehicle safely away from the roadway and contact the nearest authorized Mercedes-Benz Center or Roadside Assistance.

Have the damaged tire replaced.

•► Correct the tire pressure if it is at least 130 kPa (1.3 bar/20 psi) (for the required values, see the Tire and Loading Information placard on the driver's side B-pillar or the tire pressure table inside the fuel filler flap).

•► To increase the tire pressure: switch on the tire inflation compressor.

•► To reduce the tire pressure: press

► To reduce the tire pressure: press pressure release button 9 next to pressure gauge 10.

•► Stow the tire sealant bottle and the tire inflation compressor.

•► Drive to the nearest workshop and have the tire changed there.

•► Have the tire sealant bottle replaced as soon as possible at a qualified specialist workshop, e.g. at an authorized Mercedes- Benz Center.

Environmental note
Have the used tire sealant bottle disposed of professionally, e.g. at an authorized Mercedes-Benz Center.

•► Have the tire sealant bottle replaced every four years at a qualified specialist workshop, e.g. an authorized Mercedes- Benz Center.

    Tire pressure of at least 180 kPa (1.8 bar/26 psi) is not reached
    If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved: •► Press the on/off switch on the tire inflation compressor to 0. The tire inflation compressor is s ...

    See also:

    Chill zone beverage cooler storage compartment
    The Chill Zone Beverage Cooler Storage Compartmentis located in the top of the instrument panel on thepassenger side. A recessed latch at the front releases thebin door and swings up for easy acce ...

    Removing Discs from the Changer
    To remove the disc that is currently playing, press the eject button. You will see ‘‘EJECT’’ in the center display. When you remove the disc from the slot, the system automatically e ...

    ISOFIX/LATCH lower anchors
    Using the ISOFIX/LATCH lower child seat anchors Lower anchors for ISOFIX/LATCH-equipped child seats are located in the rear, outboard seats, hidden below the backrest cushions. Symbols on the sea ...