Mercedes-Benz E-Class: Tire pressure of at least 180 kPa (1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved:
•► Press the on/off switch on the tire inflation compressor to 0.
The tire inflation compressor is switched off.
•► Unscrew the filler hose from the valve of the faulty tire.
•► Very slowly drive forwards or reverse approximately 30 ft (10 m).
•► Pump up the tire again.
WARNING
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) cannot be achieved, the tire
is too badly damaged to be repaired reliably
using TIREFIT.
In this case TIREFIT cannot seal the tire properly.
Do not drive any further.
Contact the nearest authorized Mercedes- Benz Center for assistance or call Roadside Assistance.
Using the TIREFIT kit
You can use the TIREFIT kit to seal small punctures, particularly those in the tire tread. You can use TIREFIT at outside temperatures down to -4 °F (-20 °C). WARNING TIREFIT is a limite ...Tire pressure of 180 kPa (1.8 bar/ 26 psi) is reached
•► Press the on/off switch on the tire inflation compressor to 0. The tire inflation compressor is switched off. •► Unscrew the filler hose from the valve of the faulty tire. ...See also:
Route guidance inactive
1. Direction of travel
2. Current road ...
Emission control information label
The emission control information label is attached to the underside of the hood
as shown. ...
Battery
If the battery is not fully charged during extremely cold weather conditions,
the battery fluid may freeze and damage the battery. To maintain maximum efficiency,
the battery should be checked reg ...