Subaru Legacy: To decrease the speed (by brake pedal) - To change the cruising speed - Cruise control - Starting and operating - Subaru Legacy Owners ManualSubaru Legacy: To decrease the speed (by brake pedal)

1. Depress the brake pedal to release cruise control temporarily.

2. When the speed decreases to the desired speed, press the “RES/SET” switch to the “SET” side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.

    To decrease the speed (by the “RES/SET” switch)
    Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and tre ...

    Cruise control indicator light
    The cruise control indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. The light illuminates when the “CRUISE” ...

    See also:

    Door open indicator light
    When any of the doors, the rear gate (Outback) or the trunk lid (Legacy) is not fully closed, the door open indicator light illuminates. This function is effective even if the ignition switch is ...

    Saving a function
    1. Highlight the function via the iDrive. 2. Press the desired button for more than 2 seconds. ...

    Adjustable headrest (if so equipped)
    WARNING: The adjustable headrests supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions. Adjust the headrests properly, ...