Buick Regal: Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn.
An arrow on the instrument panel cluster flashes in the direction of the turn or lane change.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is completed. If the lever is briefly pressed and released, the turn signal flashes three times.
The turn and lane-change signal can be turned off manually by moving the lever back to its original position.
If after signaling a turn or lane change, the arrow flashes rapidly or does not come on, a signal bulb might be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse.
See Fuses and Circuit Breakers .
Hazard Warning Flashers
Hazard Warning Flasher: Press this button located on the instrument panel above the audio system, to make the front and rear turn signal lamps flash on and off. Press again to turn the flashe ...Fog Lamps
To turn on the fog lamps, the ignition and the headlamps or parking lamps must be on. If the fog lamps are turned on while the exterior lamp switch is in the AUTO position, the headlamps come on ...See also:
Explanation of general maintenance items
Additional information on the following
items with “ * ”is found later in this section.
Outside the vehicle
The maintenance items listed here should be
performed from time to time, unless othe ...
Gear Ranges
DO NOT race the engine when shifting from PARK or
NEUTRAL into another gear range. ...
If the electronic key does not operate properly (vehicles with a smart key
system)
If communication between the electronic key and the vehicle is interrupted or
the electronic key cannot be used because the
battery is depleted, the smart key system and wireless remote control
...