Buick LaCrosse: UHP Controls
Use the buttons located on the infotainment system and the steering wheel to operate the UHP system.
Steering Wheel Controls
Steering wheel controls can be
used to:
• Answer incoming calls
• Confirm system information
• Start voice recognition
• End a call
• Reject a call
• Cancel an operation
• Make outgoing calls using the call list
(Push To Talk) : Press to
answer incoming calls, to confirm
system information, and to start
voice control. Press and hold for two
to three seconds to access the
call list.
(End call/Mute) : Press to
end a call, reject a call, or to cancel
an operation.
To make outgoing calls using the call list.
1. Press the button.
2. Highlight the phone number by toggling the SRC switch up or down.
3. Dial the highlighted number by
pressing the button.
Infotainment System Controls
For information about how to navigate the menu system using the navigation system controls, see the separate Navigation System Manual.
PHONE : Press to enter the Phone main menu.
Voice Control
The voice control system uses commands to control the system and dial phone numbers.
Noise: The system may not recognize voice commands if there is too much background noise.
When to Speak: A tone sounds to indicate that the system is ready for a voice command. Wait for the tone and then speak.
How to Speak: Speak clearly in a calm and natural voice.
Audio System
When using the UHP system, sound comes through the vehicle's front audio system speakers and overrides the audio system. Use the VOL/ O knob during a call to change the volume level. The adjusted volume level remains in memory for later calls. The system maintains a minimum volume level.
Turning Bluetooth On or Off
1. Press the CONFIG button.
2. Select Phone Settings, or touch Phone on a navigation radio.
3. Select Bluetooth.
4. Select Activation.
Changing Bluetooth Code
The default Bluetooth code should work with most mobile phones.
If you are having difficulty pairing your mobile phone, you can change the code at any time.
1. Press the CONFIG button.
2. Select Phone Settings, or touch Phone on a navigation radio.
3. Select Bluetooth.
4. Select Change Bluetooth Code.
5. Enter a new four-digit code, then select OK.
Ring Tone
There are three different ring tones available for the UHP system.
To change the ring tone:
1. Press the CONFIG button.
2. Select Phone Settings, or touch Phone on a navigation radio.
3. Select Ring Tones.
4. Select Ring Tone 1, 2, or 3.
Default Settings
Selecting this option will reset the ring tones and the Bluetooth code.
Other Information
The Bluetooth word mark and logos
are owned by the Bluetooth® SIG,
Inc. and any use of such marks by
General Motors is under license.
Other trademarks and trade names
are those of their resp ...
Pairing
A Bluetooth enabled mobile phone
must be paired to the UHP system
first and then connected to the
vehicle before it can be used. See
the mobile phone manufacturer's
user guide for Bluetooth ...
See also:
Air fresheners
Most air fresheners use a solvent that could affect the vehicle interior. If
you use an air freshener, take the following precautions:
- Hanging-type air fresheners can cause permanent discoloratio ...
Manual transmission
WARNING
● Do not drive the vehicle with the clutch disengaged (i.e., when the clutch
pedal is depressed) or with the shift lever in the neutral position. Engine braking
has no effect in eit ...
Brake fluid
Checking the brake fluid level
Check the fluid level in the reservoir periodically.
The fluid level should be between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir ...