Buick Regal: Using the Call Command - Bluetooth (Voice Recognition) - Phone - Infotainment System - Buick Regal Owners ManualBuick Regal: Using the Call Command

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.

2. Say “Call.” The system responds “Call using <phone name>.

Please say the name tag,” followed by a tone.

3. Say the name tag of the person to call.

► If the system recognizes the name tag, it responds “OK, calling <name tag>” and dials the number.

► If the system does not recognize the name tag, it confirms the name tag followed by a tone. If the name tag is correct, say “Yes.” The system responds with “OK, calling <name tag>” and dials the number.

If the name tag is not correct, say “No.” The system will ask for the name tag again.

Once connected, the person called will be heard through the audio speakers.

    Using the Digit Dial Command
    1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. Aft ...

    Using the Re-dial Command
    1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. Aft ...

    See also:

    Memory storage function
    Two positions for the drivers seat, steering column, and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Set the Con ...

    Using the rear center seat belt
    If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt:pull o ...

    State emission testing (U.S. only)
    WARNING Testing of an All-Wheel Drive vehicle must NEVER be performed on a single two-wheel dynamometer. Attempting to do so will result in uncontrolled vehicle movement and may cause an accident ...