Subaru Legacy: Vehicle Dynamics Control OFF switch
Pressing the switch to deactivate the Vehicle Dynamics Control system can facilitate the following operations.
● a standing start on a steeply sloping road with a snowy, gravel-covered, or otherwise slippery surface
● extrication of the vehicle when its wheels are stuck in mud or deep snow
When the switch is pressed during engine operation, the Vehicle Dynamics Control OFF indicator light on the combination meter illuminates. The Vehicle Dynamics Control system will be deactivated. When the switch is pressed again to reactivate the Vehicle Dynamics Control system, the Vehicle Dynamics Control OFF indicator light turns off.
You should not deactivate the Vehicle Dynamics Control system except under the above-mentioned situations.
CAUTION
The Vehicle Dynamics Control system helps prevent unstable vehicle motion such as skidding using control of the brakes and engine power. Do not turn off the Vehicle Dynamics Control system unless it is absolutely necessary. If you must turn off the Vehicle Dynamics Control system, drive very carefully based on the road surface condition.
NOTE
● When the switch has been pressed to deactivate the Vehicle Dynamics Control
system, the Vehicle Dynamics Control system automatically reactivates itself the
next time the ignition switch is turned to the “LOCK” position and the engine is
restarted.
● If the switch is held down for 10 seconds or longer, the indicator light turns
off, the Vehicle Dynamics Control system is activated, and the system ignores any
further pressing of the switch. To make the switch usable again, turn the ignition
switch to the “LOCK” position and restart the engine.
● When the switch is pressed to deactivate the Vehicle Dynamics Control system,
the vehicle’s running performance is comparable with that of a vehicle that does
not have a Vehicle Dynamics Control system. Do not deactivate the Vehicle Dynamics
Control system except when absolutely necessary.
● Even when the Vehicle Dynamics Control system is deactivated, components of the
brake control system may still activate. When the brake control system is activated,
the Vehicle Dynamics Control operation indicator light illuminates.
Vehicle Dynamics Control OFF indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. The light illuminates when the Vehicle Dynamics Control OFF switch ...Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pre ...See also:
Adjusting The Seat Forward Or Rearward
The seat can be adjusted both forward and rearward.
Push the seat switch forward or rearward, the seat will
move in the direction of the switch. Release the switch
when the desired position is re ...
Voice Training
For users experiencing difficulty with the system recognizing
their voice commands or numbers the Uconnect™
Voice “Voice Training” feature may be used.
1. Press the Voice Command button,
...
Charge warning light
If this light comes on while the engine is running,
it may indicate the charging system is not functioning
properly. Turn the engine off and check
the generator belt. If the belt is loose, broken ...