Hyundai Sonata: Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever.
If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
CAUTION
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on contact with the windshield and obscure your vision.
CAUTION
• To prevent possible damage to the wipers or windshield, do not operate the
wipers when the windshield is dry.
• To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner,
or other solvents on or near them.
• To prevent damage to the wiper arms and other components, do not attempt to move
the wipers manually.
Wipers and washers
A : Wiper speed control · MIST – Single wipe · OFF – Off · INT – Intermittent wipe · LO – Low wiper speed · HI – High wiper speed B : Intermittent or Auto control wipe time adju ...Interior light
Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. ...See also:
Setting a speed
WARNING
Keep in mind that it may take a brief moment
until the vehicle has made the necessary
adjustments.
Increase or decrease the set vehicle speed to
a value that the prevailing road co ...
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Parki ...
Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 3 seconds.
The light illuminates when vehicle spee ...