Chrysler 200: Without The Ignition Key
Special care must be taken when the vehicle is towed with the ignition in the LOCK position. Flatbed towing is the preferred towing method. However, if a flatbed towing vehicle is not available, wheel lift towing equipment may be used. Rear towing (with the front wheels on the ground) is not allowed, as transmission damage will occur. If rear towing is the only alternative, the front wheels must be placed on a towing dolly. Proper towing equipment is necessary to prevent damage to the vehicle.
CAUTION!
Failure to follow these towing methods can cause
severe damage to the transmission. Such damage is
not covered by the New Vehicle Limited Warranty.
Dual Dry Clutch (6-Speed C635 Ddct) Automatic Transmission
This vehicle must be towed with the front wheels OFF
the ground (using a flatbed truck, towing dolly, or wheel
lift equipment with the front wheels raised). The manufacturer
recommends towing yo ...
See also:
To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid ( ...
Low tire pressure message
The yellow warning lamp lights
up. A
Check Control message is displayed.
▷ There is a flat tire or a major loss in
tire inflation pressure.
▷ The system was not reset after a whee ...
Roof
Sunroof
On vehicles with a sunroof, the switches are on the overhead console.
The sunroof only operates when the ignition is in ON/RUN or ACC/ ACCESSORY or in Retained Accessory Power (RAP). See R ...
