Subaru Legacy: All-Wheel Drive warning light (AT and CVT models) - Warning and indicator lights - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: All-Wheel Drive warning light (AT and CVT models)

WARNING

WARNING

Continued driving with the AWD warning light flashing can lead to powertrain damage. If the AWD warning light flashes, promptly park in a safe place then check whether all four tires are the same diameter and whether any of the tires has a puncture or has lost air pressure for some other reason.

The All-Wheel Drive warning light illuminates when the ignition switch is turned to the “ON” position and turns off after the engine has started.

Windshield washer fluid warning light
This light illuminates when the fluid level in the windshield washer fluid tank decreases to the lower limit (approximately 0.6 US qt, 0.6 liter, 0.5 Imp qt). ...

For AT models
This light flashes if the vehicle is driven with tires of different diameters fitted on its wheels or with the air pressure excessively low in any of its tires. ...

See also:

Introduction
Air conditioning The vehicle is equipped with Electronic Climate Control (ECC). The climate control system cools, heats or dehumidifies the air in the passenger compartment. NOTE The air ...

Customer Information and Reporting Safety Defects
Important consumer information including warranties and add-on equipment. ...

Warning triangle
The warning triangle is located in the container on the inside of the trunk lid. Unscrew the wing nut to open. ...