Subaru Legacy: Auto-store
Using the Auto-store function, you can automatically store 6 stations on the current waveband by pressing the “A.S” button for more than 2 seconds. Use Autostore to quickly find the strongest stations, for example when traveling through different reception areas.
NOTE
● When you use Auto-store, the new stations replace any stations previously stored.
● Interrupting Auto-store: If you accidentally press the “A.S” (Auto-store) button, you can cancel the Auto-store function before it has been completed as follows.
– Switching to the other source
– Switching to the other band
– Press the “A.S” button
– Press the “SCAN” button
– Press the “SEEK” button
– Press any of the preset buttons
– Turn the “TUNE/TRACK/CH” dial
– Turn off the audio system
– Turn off the ignition switch
● When you use the Auto-store function while selecting the FM mode, even if you have selected the FM1 or FM2 station, the new stations are stored in the FM3 station.
● If it is only possible to receive less than 6 stations, the available stations are stored from preset 1 in order by frequency and the unused preset buttons are not registered to a station.
Also, the previously registered station memories of the unused preset buttons are cleared.
● If no stations can be received, the previously stored stations are not replaced.
● After pressing the “A.S” button, if more than 1 station is stored, the radio receives the station stored in preset 1.
● After pressing the “A.S” button, if no stations are stored, the radio receives the band and station that the radio received before pressing the button.
Selecting preset stations
Presetting a station with a preset button allows you to select that station in
a single operation. Up to six AM, FM1, FM2 and FM3 stations each may be preset. ...
Satellite radio operation (if equipped)
To receive satellite radio, it is necessary to install the SUBARU genuine satellite
receiver for some models, and to enter into a contract with a satellite radio network
service such as “XMTM sa ...
See also:
Speedometer with segments
The segments in the speedometer indicate
which speed range is available.
Cruise control activated:
The segments light up from the stored speed to the maximum speed.
DISTRONIC PLUS activated:
One ...
Important safety notes
! A license agreement must exist in order
to activate the mbrace service. Ensure that
your system is activated and ready for use,
and press the MB Info call button
to
register. If any of th ...
Calling up information on the info
display
Calling up information on the info
display
Press the computer button on the turn signal
lever.
Information is displayed on the info display of the
instrument cluster. ...