BMW 5 Series: Calls with multiple participants
General information
You can switch between calls or connect two calls to a single conference call. These functions must be supported by the mobile phone and service provider.
Accepting a call while speaking to another party
This function might have to be activated by the service provider and the mobile phone must be adjusted accordingly.
If a second call comes in during an ongoing call, a call waiting signal is sounded where appropriate.
"Accept"
The call is accepted and the existing call is put on hold.
Establishing a second call
Establish an additional call during an active call.
1. "Telephone"
2. "Active calls"
3. "Hold"
The existing call is put on hold.
4. Dial the new phone number or select it from a list
"Return"
The call on hold is resumed.
Switching between two calls, hold call
The active call is displayed in color.
The call on hold is displayed in gray.
"Swap calls"
The call on hold is resumed.
Establishing a conference call
Two calls can be connected to a single telephone conference call.
1. Establish two calls.
2. "Conference call"
When terminating a conference call, both calls are ended. If one call is terminated by another party, the other call can be continued.
Entering a phone number
Dialing a number When entering phone numbers, you can switch between entering letters and numbers. Service numbers can be entered more easily, e. g. 1-888-BMW-CARD. 1. "Telephone" 2. ...Switching the microphone to mute
When a call is active, the microphone can be muted. 1. "Telephone" 2. "Active calls" 3. "Microphone mute" A microphone that has been switched to mute is automatic ...See also:
Starting the Vehicle Messages
JUMP START ACTIVE WAIT TO
START
This message displays while
performing an on-board jump start
of the vehicle. See “Jump Starting
(On-board with eAssist Only)” for
more information.
JUM ...
Spark plugs
Make sure to install new spark plugs of the correct heat range. ...
Engine
NOTICE
■Drive belt type (2.5 L 4-cylinder [2AR-FE] engine only)
The high strength drive belt is used for the generator side drive belt.
When replacing the drive belt, use Toyota genuine dr ...