Subaru Legacy: Cargo area light (Outback) - Replacing bulbs - Maintenance and service - Subaru Legacy Owners ManualSubaru Legacy: Cargo area light (Outback)

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

2. Pull the bulb out of the socket.

2. Pull the bulb out of the socket.

3. Install a new bulb.

4. Reinstall the lens.

    Door step light
    1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the lens. ...

    Trunk light (Legacy)
    1. Push both sides of the light cover, and then remove the cover by pulling it out. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the cover. ...

    See also:

    Drive-off assistant
    This system supports driving away on gradients. The parking brake is not required. 1. Hold the vehicle in place with the foot brake. 2. Release the foot brake and drive away without delay. After ...

    Storage compartments
    The following storage compartments are available in the vehicle interior: ▷ Glove compartment on the driver's and front passenger side. ▷ Storage compartment on the center console: ...

    Engine compartment
    CAUTION: Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not ...