Honda Accord: Check Fuel Cap Message - Before Driving - Honda Accord Owners ManualHonda Accord: Check Fuel Cap Message

Your vehicle’s onboard diagnostic

Your vehicle’s onboard diagnostic system will detect a loose or missing fuel fill cap as an evaporative system leak. The first time a leak is detected a ‘‘CHECK FUEL CAP’’ message appears on the information display.

Turn the engine off, and confirm the fuel fill cap is installed. If it is, loosen it, then retighten it until it clicks at least once. The message should go off after several days of normal driving once you tighten or replace the fuel fill cap. To scroll to another display, press the select/reset knob.

The ‘‘CHECK FUEL CAP’’ message will appear each time you restart the engine until the system turns the message off.

If the system still detects a leak in your vehicle’s evaporative emissions system, the malfunction indicator lamp (MIL) comes on. If the fuel fill cap was not already tightened, turn the engine off, and check or retighten the fuel fill cap until it clicks at least once. The MIL should go off after several days of normal driving once the cap is tightened or replaced. If the MIL does not go off, have your vehicle inspected by a dealer. For more information, see page .

406

    Refueling
    1. Park with the driver’s side closest to the service station pump. 2. To open the fuel fill door, push down on the lever located to the left of the driver’s seat. Gasoline is highly f ...

    Opening and Closing the Hood
    1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the ho ...

    See also:

    NISSAN Intelligent Key™ operation
    Coupe shown, Sedan similar You can lock or unlock the doors without taking the key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or unlock all doors by pus ...

    Checking the engine oil level
    1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

    Vehicle loading
    Vehicle Certification Label Your vehicle has a certification label attached to the rearof the driver’s door. The label contains the following information: • Name of manufacturer. • Month and ...