BMW 5 Series: Connecting electrical devices - Interior equipment - Controls - BMW 5 Series Owners ManualsBMW 5 Series: Connecting electrical devices

Sockets

The lighter socket can be used as a socket for electrical equipment while the engine is running or when the ignition is switched on. The total load of all sockets must not exceed 140 watts at 12 volts.

Do not damage the socket by using unsuitable connectors.

Front center console: manual transmission

Press on the cover.

Press on the cover.

Remove the cover or cigarette lighter.

Front center console: automatic transmission

Press on the cover.

Press on the cover.

Remove the cover or cigarette lighter.

Center armrest

Remove cover.

Remove cover.

Rear center console

Remove the cover or cigarette lighter.

Remove the cover or cigarette lighter.

In the front passenger footwell

Socket is located below the glove compartment.

Socket is located below the glove compartment.

To access the socket: fold open the cover.

In the cargo area

The socket is located in the cover of the loading lip.

To access the socket: fold open the cover.

    Rear
    Opening Press on the cover. Emptying Take out the insert. Lighter Push in the lighter. The lighter can be removed as soon as it pops back out. Danger of burns Only hold the hot lighter ...

    Through-loading system
    General information The cargo area can be enlarged by folding down the rear seat backrest. The rear seat backrest is divided into two parts at a ratio of 60 to 40. The sides can be folded down ...

    See also:

    Drive belts
    Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if necessary. Drive belts should be checked periodically for proper tension and adjusted as neces ...

    Manual transmission (if so equipped)
    WARNING ● Do not downshift abruptly on slippery roads. This may cause a loss of control. ● Do not over-rev the engine when shifting to a lower gear. This may cause a loss of control o ...

    Tire labeling
     Example Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics o ...