Subaru Legacy: Cruise control indicator light
The cruise control indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds.
The light illuminates when the “CRUISE” main switch is pressed.
NOTE
● If you press the “CRUISE” main switch button while turning the ignition switch “ON”, the cruise control function is deactivated and the cruise control indicator light flashes. To reactivate the cruise control function, turn the ignition switch back to the “Acc” or “LOCK” position, and then turn it again to the “ON” position.
● If this indicator light and the CHECK ENGINE warning light/malfunction indicator lamp flash simultaneously during driving, have the vehicle checked by your nearest SUBARU dealer.
To decrease the speed (by brake pedal)
1. Depress the brake pedal to release cruise control temporarily. 2. When the speed decreases to the desired speed, press the “RES/SET” switch to the “SET” side once. Now the desired speed ...Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. The light illuminates when vehicle spee ...See also:
Spare Tire Matching Original Equipped Tire And Wheel – If Equipped
Your vehicle may be equivalent with a spare tire and
wheel in look and function as the original equipment tire
and wheel found on the front or rear axle of your vehicle.
This spare tire may be us ...
Certification for the smart key system
U.S.A.
FCC ID: NI4TMLF10-4
FCC ID: NI4TMLF10-5
FCC ID: HYQ23AAB
FCC ID: HYQ14FBA
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: ...
Manual Type
Manual Type
Control Switches
Temperature
control dial
This dial controls temperature. Turn it clockwise for hot and counterclockwise
for cold.
MAX-A/C position
For quick cabin cooling, rota ...