Buick LaCrosse: Daytime Running Lamps (DRL) - Exterior Lighting - Lighting - Buick LaCrosse Owners ManualBuick LaCrosse: Daytime Running Lamps (DRL)

Daytime Running Lamps (DRL) can make it easier for others to see the front of your vehicle during the day.

Fully functional daytime running lamps are required on all vehicles first sold in Canada.

The DRL system turns on the low-beam headlamps at a reduced brightness. For vehicles with High Intensity Discharge (HID) headlamps, the dedicated DRL will come on when all of the following conditions are met:

• The ignition is on.

• The exterior lamps control is in AUTO.

• The light sensor determines it is daytime.

• The parking brake is released or the vehicle is not in P (Park).

When the DRL are on, the low-beam headlamps will be on.

The taillamps, sidemarker lamps, instrument panel lights, and other lamps will not be on.

The DRL turn off when the headlamps are turned to ignition is off. or the ignition is off.

This vehicle may have a DRL disabling function. When the DRL are on and a turn signal is activated, the DRL on that side will be off until the turn signal goes off.

    Flash-to-Pass
    To flash the high beams, pull the turn signal/lane change lever toward you, and release. ...

    Automatic Headlamp System
    When the exterior lamp control is set to AUTO and it is dark enough outside, the headlamps come on automatically. There is a light sensor located on top of the instrument panel. Do not co ...

    See also:

    Uconnect™ Multimedia (Satellite Radio) — If Equipped
    Satellite radio uses direct satellite-to-receiver broadcasting technology to provide clear digital sound, coast to coast. The subscription service provider is Sirius Satellite Radio. This servic ...

    Average Fuel Economy/Instantaneous Fuel Economy
    On some models, this display shows Average Fuel Economy. On other models, this display shows both Average Fuel Economy and Instantaneous Fuel Economy. The Average Fuel Economy display shows ...

    Operation
    Controls and display 1 - Resume previous settings, increase speed (each additional press increases speed by 2 - 1 mph (approximately 2 km/h). 3 - Standby mode on/off 4 - Set time interval 5 ...