Mazda Mazda6: Driving on Uneven Road - Before Driving Your Mazda - Mazda6 Owners ManualMazda Mazda6: Driving on Uneven Road

Your vehicle's suspension and underbody can be damaged if driven on rough/uneven roads or over speed bumps at excessive speeds. Use care and reduce speed when traveling on rough/uneven roads or over speed bumps.

Use care not to damage the vehicle's underbody, bumpers or muffler(s) when driving under the following conditions:

- Ascending or descending a slope with a sharp transition angle.

- Ascending or descending a driveway or trailer ramp with a sharp transition angle.

Your vehicle is equipped with low profile tires allowing class-leading performance

Your vehicle is equipped with low profile tires allowing class-leading performance and handling. As a result, the sidewall of the tires are very thin and the tires and wheels can be damaged if driven through potholes or on rough/uneven roads at excessive speeds. Use care and reduce speed when traveling on rough/uneven roads or through potholes.

    Overloading
    WARNING: Be careful not to overload your vehicle: The gross axle weight rating (GAWR) and the gross vehicle weight rating (GVWR) of your vehicle are on the Motor Vehicle Safety Standard Label on t ...

    Trailer Towing
    The Mazda6 is not designed for towing. Never tow a trailer with your Mazda6. ...

    See also:

    If the Vehicle Is Stuck
    Slowly and cautiously spin the wheels to free the vehicle when stuck in sand, mud, ice, or snow. If stuck too severely for the traction system to free the vehicle, turn the traction system off and us ...

    The Blind Spot Monitor detection areas
    The blind spot that vehicles can be detected in are outlined below. The range of the detection area extends to: Approximately 11.5 ft. (3.5 m) from the side of the vehicle The first 1.6 ...

    Synthetic leather upholstery
    The synthetic leather material used on the SUBARU may be cleaned using mild soap or detergent and water, after first vacuuming or brushing away loose dirt. Allow the soap to soak in for a few minu ...