Buick Regal: Engine Oil Messages - Vehicle Messages - Instruments and Controls - Buick Regal Owners ManualBuick Regal: Engine Oil Messages

CHANGE ENGINE OIL SOON

This message displays when the engine oil needs to be changed.

When you change the engine oil, be sure to reset the Oil Life System.

See Engine Oil Life System  and Driver Information Center (DIC)  for information on how to reset the system. See Engine Oil  and Scheduled Maintenance  for more information.

ENGINE OIL HOT, IDLE ENGINE

This message displays when the engine oil temperature is too hot.

Stop and allow the vehicle to idle until it cools down.

ENGINE OIL LOW — ADD OIL

This message displays when the engine oil level is too low. Check the oil level. See Engine Oil .

OIL PRESSURE LOW — STOP ENGINE

This message displays if low oil pressure levels occur. Stop the vehicle as soon as safely possible and do not operate it until the cause of the low oil pressure has been corrected. Check the oil as soon as possible and have the vehicle serviced by your dealer.

    Engine Cooling System Messages
    A/C OFF DUE TO HIGH ENGINE TEMP This message displays when the engine coolant becomes hotter than the normal operating temperature. To avoid added strain on a hot engine, the air conditioning compre ...

    Engine Power Messages
    ENGINE POWER IS REDUCED This message displays when the vehicle's engine power is reduced. Reduced engine power can affect the vehicle's ability to accelerate. If this message is on, but there is no ...

    See also:

    General notes
    The roller sunblinds shield the vehicle interior from sunlight. The two roller sunblinds can only be opened and closed together when the panorama roof with power tilt/sliding panel is closed. ...

    Good braking practices
    WARNING • Whenever you leave or park your vehicle, always set the parking brake as far as possible and fully engage the vehicle's transaxle into the P (Park) position. If the parking brake ...

    Important notes on use
    To function properly, BlueTEC exhaust gas aftertreatment must be operated with the reducing agent DEF. Adding DEF is one of the tasks performed during maintenance. Under normal operating condi ...