Chrysler 200: Engine Oil Viscosity (SAE Grade) – 2.4L Engine - Engine Oil - Maintenance Procedures - Maintaining your vehicle - Chrysler 200 Owners ManualChrysler 200: Engine Oil Viscosity (SAE Grade) – 2.4L Engine

Chrysler 200 / Chrysler 200 Owners Manual / Maintaining your vehicle / Maintenance Procedures / Engine Oil / Engine Oil Viscosity (SAE Grade) – 2.4L Engine

SAE 5W-20 engine oil is recommended for all operating temperatures. This engine oil improves low temperature starting and vehicle fuel economy. Your engine oil filler cap also shows the recommended engine oil viscosity for your vehicle.

The engine oil filler cap also shows the recommended engine oil viscosity for your engine. For information on engine oil filler cap location, refer to “Engine Compartment” in “Maintaining Your Vehicle” for further information.

Lubricants which do not have both the engine oil certification mark and the correct SAE viscosity grade number should not be used.

    American Petroleum Institute (API) Engine Oil Identification Symbol
    This symbol means that the oil has been certified by the American Petroleum Institute (API). The manufacturer only recommends API Certified engine oils. CAUTION! Do not use chemical flushe ...

    Engine Oil Viscosity (SAE Grade) – 3.6L Engine
    SAE 5W-30 engine oil is preferred for all operating temperatures. The engine oil filler cap also shows the recommended engine oil viscosity for your vehicle. Lubricants which do not have both, th ...

    See also:

    Power Steerin
    If power steering assist is lost because the engine stops or the power steering system is not functioning, the vehicle can be steered but it will take more effort. ...

    Driver distraction
    A driver has a responsibility to do everything possible to ensure his or her own safety and the safety of passengers in the vehicle and others sharing the roadway. Avoiding distractions is part of ...

    Drive belt
    1. Power steering fluid pump. 2. Generator. 3. Air conditioner compressor. 4. Crankshaft pulley. WARNING: Be sure the ignition switch is in the OFF or LOCK position before servicing drive bel ...