Buick LaCrosse: Erasing Universal Remote 
System Buttons - Universal Remote System Operation - Universal Remote System - Instruments and Controls - Buick LaCrosse Owners ManualBuick LaCrosse: Erasing Universal Remote System Buttons

All programmed buttons should be erased when the vehicle is sold or the lease ends.

To erase all programmed buttons on the Universal Remote system device:

1. Press and hold down the two outside buttons until the indicator light begins to flash.

This should take about 10 seconds.

2. Release both buttons.

    Using the Universal Remote System
    Press and hold the appropriate Universal Remote system button for at least half of a second. The indicator light will come on while the signal is being transmitted. ...

    Reprogramming a Single Universal Remote System Button
    To reprogram any of the three Universal Remote system buttons: 1. Press and hold the desired Universal Remote system button. Do not release the button. 2. The indicator light will begin to ...

    See also:

    Vehicle break-in process
    No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle. Do not race the ...

    Ceiling Light
    The ceiling light has a three-position switch: ON, Door Activated, and OFF. In the Door Activated (center) position, the light comes on when you: Open either door. Unlock the driver’s do ...

    Folding rear seat (if so equipped)
    Interior trunk access For models without a rear center console, the trunk can be accessed from the passenger side of the rear seat for loading and unloading, as shown. (1) Push down on the button ...