Volvo S60: Fastening a seat belt - General information - Seat belts - Safety - Volvo S60 Owners ManualVolvo S60: Fastening a seat belt

Buckling

Pull the belt out far enough to insert the latch plate into the receptacle until a distinct click is heard. The seat belt retractor is normally "unlocked" and you can move freely, provided that the shoulder belt is not pulled out too far.

Adjusting seat belt height (front seat belts only)

Adjusting seat belt height

Adjusting seat belt height

The height of the shoulder section of the seat belt must be correctly adjusted. Press the button and move the upper seat belt anchor to position it as high as possible so that the shoulder section of the belt is across the seat occupant's collarbone and not across the throat.

Correct height adjustment

Correct height adjustment

Incorrect height adjustment

Incorrect height adjustment

Seat belt retractor

The seat belt retractor will lock up in the following situations:

  • if the belt is pulled out rapidly
  • during braking and acceleration
  • if the vehicle is leaning excessively
  • when driving in turns
  • if the Automatic Locking Retractor/Emergency Locking Retractor (ALR/ELR) is activated

NOTE NOTE

Each seat belt (except for the driver's belt) is equipped with the ALR/ELR function, which is designed to help keep the seat belt taut. ALR/ELR activates if the seat belt is pulled out as far as possible. If this is done, a sound from the seat belt retractor will be audible, which is normal, and the seat belt will be pulled taut and locked in place. This function is automatically disabled when the seat belt is unbuckled and fully retracted.

See also page 40 for information about using a seat belt's ALR/ELR function to anchor a child seat.

When wearing the seat belt remember:

  • The belt should not be twisted or turned.
  • The lap section of the belt must be positioned low on the hips (not pressing against the abdomen).
  • Make sure that the shoulder belt is rolled up into its retractor and that the shoulder and lap belts are taut.
    Seat belt pretensioners
    All seat belts are equipped with pretensioners that reduce slack in the belts. These pretensioners are triggered in situations where the front or side impact airbags deploy, and in certain impacts ...

    Unbuckling the seat belt
    To remove the seat belt, press the red section on the seat belt receptacle. Before exiting the vehicle, check that the seat belt retracts fully after being unbuckled. If necessary, guide the belt ...

    See also:

    Components in the SIPS airbag system
    This SIPS airbag system consists of a gas generator, the side airbag modules built into the outboard sides of both front seat backrests, and electronic sensors/wiring. WARNING The SIPS air ...

    Using the parking aid
    Switching the parking aid onand off Note: The parking aid switches offautomatically when you start the engineor when you exceed 16 km/h (10 mph). Note: The front and rear sensors arealways activated ...

    Manual drive program
    Switching on the manual drive program The manual drive program is only available for AMG vehicles. Manual drive program M is different from drive programs S and S+ with regard to spontaneity, ...