Buick Regal: Front Turn Signal/Parking/Side Marker Lamps (Base and Up-Level)
To replace the front turn signal, parking lamp, or sidemarker lamp:
1. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.
2. Remove the bulb socket from the headlamp assembly by turning it counterclockwise.
3. Remove the bulb from the socket.
4. Replace the bulb in the bulb socket.
5. Install the bulb socket in the headlamp assembly by turning it clockwise.
6. For the driver side, reinstall the windshield washer bottle filler neck by firmly pushing it straight into the bottle. Ensure that the filler neck clip engages into the underhood electrical center retainer.
High/Low-Beam Headlamps (Up-Level)
The high/low-beam headlamps on the up-level headlamp system are High Intensity Discharge (HID) and should be replaced at the dealer. ...
Fog Lamps
To replace the fog lamp bulb:
1. Locate the bulb assembly under the front fascia.
2. Disconnect the electrical connector from the bulb assembly.
3. Remove the bulb by turning it counterclockwise an ...
See also:
Using a flatbed truck
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45В°.
Do not overly tighten the tie
downs or the vehicle may be
damaged.
NOTICE
■To prevent ...
Front seats
1 - Lumbar support: turn the control for firmer or softer lumbar support.
2 - Front-rear adjustment: lift the bar and move the seat to the position of
your choice.
3 - Raise/lower front edge of ...
When checking or servicing in the engine compartment while the engine is running
WARNING
A running engine can be dangerous. Keep your fingers, hands, clothing, hair and
tools away from the cooling fan, belts and any other moving engine parts. Removing
rings, watches and ties ...
