Buick LaCrosse: Fuel Gauge - Warning Lights, Gauges, and Indicators - Instruments and Controls - Buick LaCrosse Owners ManualBuick LaCrosse: Fuel Gauge

Metric
Metric

English
English

When the ignition is on, the fuel gauge indicates about how much fuel is left in the tank.

An arrow on the fuel gauge indicates the side of the vehicle the fuel door is on.

When the indicator nears empty, the low fuel light comes on. There is still a little fuel left, but the fuel tank should be filled soon.

Here are four things that some owners ask about. None of these show a problem with the fuel gauge:

• At the service station, the fuel pump shuts off before the gauge reads full.

• It takes a little more or less fuel to fill up than the gauge indicated. For example, the gauge indicated the tank was half full, but it actually took a little more or less than half the tank's capacity to fill the tank.

• The gauge moves a little while turning a corner or speeding up.

• The gauge takes a few seconds to stabilize after the ignition is turned on, and goes back to empty when the ignition is turned off.

    Tachometer
    The tachometer displays the engine speed in revolutions per minute (rpm). For eAssist vehicles, when the ignition is in ON/RUN, the tachometer indicates the vehicle status. When pointing to ...

    Driver Efficiency Gauge
    For eAssist vehicles, this gauge assists in driving efficiently and will vary based on driver input. To maximize efficiency, keep the gauge pointed in the solid green zone in the center of ...

    See also:

    Introduction
    All bulb specifications are listed on page 311. The following bulbs should only be replaced by a trained and qualified Volvo service technician: Dome lighting Reading lights Glove compartmen ...

    After completing the tire change (vehicles with a tire pressure warning system)
    The tire pressure warning system must be reset. ...

    Programming the HomeLink®
    Point the remote control transmitter for the device 1 to 3 in. (25 to 75 mm) from the HomeLink® control buttons. Keep the HomeLink® indicator light in view while programming. Press and ...