Mercedes-Benz E-Class: General notes - Convenience closing - Side windows - Opening/closing - Mercedes-Benz E-Class Owners ManualMercedes-Benz E-Class: General notes

When you lock the vehicle, you can simultaneously:

- close the side windows
- close the sliding sunroof or the panorama roof with power tilt/sliding panel

On vehicles with a panorama roof with power tilt/sliding panel, you can then close the roller sunblinds.

WARNING
When closing the door windows and the sliding sunroof or panorama roof with power tilt/sliding panel, make sure that there is no danger of anyone being harmed by the closing procedure.

If potential danger exists, proceed as follows:

- Release the the closing  button to stop the closing procedure. To open, press and hold the procedure after making sure that there is button. To continue the closing procedure after making sure that there is no danger of anyone being harmed by the closing procedure, press and hold the Vehicles with KEYLESS-GO: button.

Vehicles with KEYLESS-GO:

 - Release the sensor surface on the outside door handle to stop the closing procedure.
 - Immediately pull on the same outside door handle and hold firmly. The door windows and the sliding sunroof or panorama roof with power tilt/sliding panel will open for as long as the door handle is held but the door is not opened.

    Using the SmartKey
    The SmartKey must be close to the driver's door handle. •► Point the tip of the SmartKey at the driver's door handle. •► Press and hold the button until the side windows and ...

    See also:

    Main Menu
    Start a dialogue by pressing the Voice Command button. You may say “Main Menu” to switch to the main menu. In this mode, you can say the following commands: • “Radio” (to switch to ...

    FM selection
    Press the “FM” button when the radio is on to select FM1, FM2 or FM3 reception. Each brief press of the “FM” button changes the radio in the following sequence starting from the last FM r ...

    Moonroof
    When power window switch does not operate If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system: ...