Dodge Avenger: Hazard warning flasher
The Hazard Warning flasher switch is
located on theinstrument panel, below the radio.
Press the switch to turn on the Hazard Warningflasher. When the switch is activated, all directionalturn signals will flash on and off to warn oncomingtraffic of an emergency. Press the switch a second time toturn off the Hazard Warning flasher.
This is an emergency warning system and should not beused when the vehicle is in motion. Use it when yourvehicle is disabled and is creating a safety hazard forother motorists.
If it is necessary to leave the vehicle to go for service, theHazardWarning flasher will continue to operate with theignition key removed and the vehicle locked.
NOTE: With extended use, the Hazard Warning flashermay wear down your battery.
If your engine overheats
In any of the following situations, you can reduce thepotential for overheating
by taking the appropriate action.
• On the highways — Slow down.
• In city traffic — While stopped, put tran ...
See also:
Introduction
Information display and controls
1 - READ–press to acknowledge/confirm/ erase a message)
2 - Thumb wheel (used to scroll among the trip computer menus)
3 - RESET–resets certain functions
To ...
When riding in an aircraft (vehicles with a wireless remote control)
When bringing a key with wireless remote control function onto an aircraft,
make sure you do not press any buttons on the key while inside the aircraft
cabin. If you are carrying the key in your b ...
General information
1. Turn the controller: select letters or numbers.
2. Select additional letters or numbers if
needed.
3. "OK": confirm the entry.
...
