Buick LaCrosse: Head Restraint Removal and 
Reinstallation - Lower Anchors and Tethers for Children (LATCH System) - Child Restraints - Seats and Restraints - Buick LaCrosse Owners ManualBuick LaCrosse: Head Restraint Removal and Reinstallation

The rear outboard head restraints can be removed if they interfere with the proper installation of the child restraint.

To remove the head restraint:

1. Partially fold the seatback forward. See Rear Seats for additional information.

2. Press both buttons on the head

2. Press both buttons on the head restraint posts at the same time, and pull up on the head restraint.

3. Store the head restraint in the trunk of the vehicle.

4. When the child restraint is removed, reinstall the head restraint before the seating position is used.

WARNING!
With head restraints that are not installed and adjusted properly, there is a greater chance that occupants will suffer a neck/spinal injury in a crash. Do not drive until the head restraints for all occupants are installed and adjusted properly.

To reinstall the head restraint:

1. Insert the head restraint posts

1. Insert the head restraint posts into the holes in the top of the seatback. The notches (A) on the posts must face the driver side of the vehicle.

2. Push the head restraint down.

If necessary, press the height adjustment release button to further lower the head restraint.

See Head Restraints.

3. Try to move the head restraint to make sure that it is locked in place.

    Securing a Child Restraint Designed for the LATCH System
    WARNING! If a LATCH-type child restraint is not attached to anchors, the child restraint will not be able to protect the child correctly. In a crash, the child could be seriously injured or ...

    Replacing LATCH System Parts After a Crash
    WARNING! A crash can damage the LATCH system in the vehicle. A damaged LATCH system may not properly secure the child restraint, resulting in serious injury or even death in a crash. To hel ...

    See also:

    Type B audio set (if equipped)
    The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. ● Power and sound controls: refer to page 5-6 ● Radio operation: refer to page 5-9 ...

    Starting the Engine
    With advanced key Refer to “Starting the engine” for information on how to start the engine. NOTE: Engine-starting is controlled by the spark ignition system. This system meets all Canadian In ...

    Programming A Non-Rolling Code
    For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...