Nissan Maxima: Heated steering wheel (if so equipped) - Instruments and controls - Nissan Maxima Owners ManualNissan Maxima: Heated steering wheel (if so equipped)

The heated steering wheel system is designed to operate only when the surface

The heated steering wheel system is designed to operate only when the surface temperature of the steering wheel is below 68°F (20°C).

Push the heated steering wheel switch to warm the steering wheel after the engine starts. The indicator light will come on.

If the surface temperature of the steering wheel is below 68°F (20°C), the system will heat the steering wheel and cycle off and on to maintain a temperature above 68°F (20°C). The indicator light will remain on as long as the system is on.

Push the switch again to turn the heated steering wheel system off manually. The indicator light will go off.

NOTE:

If the surface temperature of the steering wheel is above 68°F (20°C) when the switch is turned on, the system will not heat the steering wheel. This is not a malfunction.

    Heated seats (if so equipped)
    The front seats are warmed by built-in heaters. The switch is located on the center console. 1. Start the engine. 2. Push the LO or HI position of the switch, as desired. The indicator light in ...

    Vehicle Dynamic Control (VDC) OFF switch
    The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to re ...

    See also:

    Automatic climate control system
    To defog inside windshield 1. Select desired fan speed. 2. Select desired temperature. 3. Press the defrost button ( ). 4. The outside (fresh) air position will be selected automatically. If th ...

    Voice Pass-Thru
    Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature. To access cont ...

    Cargo area light (Outback)
    1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Pull the bulb out of the socket. 3. Install a new bulb. 4. Reinstall the lens. ...