Buick Regal: Hood
To open the hood:
1. Pull up on the hood release handle with this symbol on it.
It is located inside the vehicle to the left of the steering column.
2. Go to the front of the vehicle and move the secondary hood release handle to the right.
To close the hood:
1. Before closing the hood, be sure all the filler caps are on properly.
2. Lower the hood 30 cm (12 in) above the vehicle and release it so it fully latches. Check to make sure the hood is closed and repeat the process if necessary.
Doing Your Own Service Work
WARNING You can be injured and the vehicle could be damaged if you try to do service work on a vehicle without knowing enough about it. ► Be sure you have sufficient knowledge, experience, ...Engine Compartment Overview
2.0 L L4 Engine A. Engine Air Cleaner/Filter . B. Engine Cover. C. Engine Oil Dipstick. See Engine Oil . D. Engine Oil Fill Cap. See Engine Oil . E. Transmission Fluid Cap and Dipstick. See Auto ...See also:
How to insert a CD (type A)
While the ignition switch is in the “Acc” or “ON” position, hold a disc with
a finger in the center hole while gripping the edge of the disc, then insert it
in to the slot (with the label ...
Push-starting
Your manual transaxle-equipped vehicle should not be push-started because it
might damage the emission control system. Vehicles equipped with automatic transaxle
cannot be push-started. Follow the ...
Rapid air pressure loss
Rapid air pressure loss or a blow-out can occur if the tire is punctured or is
damaged due to hitting a curb or pothole. Rapid air pressure loss can also be caused
by driving on under-inflated tir ...