BMW 5 Series: Incoming call
Receiving calls
If the number of the caller is stored in the phone book and is transmitted by the network, the name of the contact is displayed. Otherwise, only the phone number is displayed.
If more than one phone number is assigned to a contact, only the name of the contact is displayed.
For calls on the additional telephone, the number is only displayed if it is transmitted by the network.
An incoming call to the additional telephone is automatically rejected if there is an active call on the other telephone.
Accepting a call
Via iDrive
"Accept"
Via the button on the steering wheel
Press the button.
Via the instrument cluster
"Accept"
Rejecting a call
Via iDrive
"Reject"
Via the instrument cluster
"Reject"
Ending a call
Via iDrive
"End call"
Via the button on the steering wheel
Press the button.
Via the instrument cluster
"End call"
Adjusting the volume
Turn the knob until the desired volume is selected. The setting is stored for the remote control currently in use. The vehicle automatically adjusts the volume of the microphone on the telephone ...Entering a phone number
Dialing a number When entering phone numbers, you can switch between entering letters and numbers. Service numbers can be entered more easily, e. g. 1-888-BMW-CARD. 1. "Telephone" 2. ...See also:
Operation
Controls and display
1 - Resume previous settings, increase speed (each additional press increases
speed by 2 - 1 mph (approximately 2 km/h). 3 - Standby mode on/off 4 - Set time
interval 5 ...
Catalytic converter
Driving with a catalyticconverter
CAUTIONS:
Avoid running out of fuel.
Do not crank the engine for longperiods.
Do not run the engine when a sparkplug lead is disconnected.
Do not push-start or t ...
Wiper intermittent time control
When the wiper switch is in the “INT” position, turn the dial to adjust the operating
interval of the wiper. The operating interval can be adjusted in five steps from
the shortest interval t ...