Toyota Camry: Indicators
The indicators inform the driver of the operating state of the vehicle’s various systems.
Turn signal indicator
Headlight high beam indicator
Slip indicator
VSC OFF indicator
“TRAC OFF” indicator
Security indicator
Type A
Shift position and shift range indicators
Type B
Shift position and shift range indicators
Smart key system indicator
BSM outside rear view mirror indicators
Headlight indicator
Tail light indicator
Front fog light indicator
SRS airbag on-off indicator
Cruise control indicator
Cruise control set indicator
Eco Driving Indicator Light
*1: These lights turn on when the engine switch is turned to the “ON” position (vehicles without a smart key system) or the “ENGINE START STOP” switch is turned to IGNITION ON mode (vehicles with a smart key system) to indicate that a system check is being performed. They will turn off after the engine is started, or after a few seconds. There may be a malfunction in a system if a light does not come on, or if the lights do not turn off. Have the vehicle inspected by your Toyota dealer.
*2: In order to confirm operation, the BSM outside rear view mirror indicators illuminate in the following situations:
• When the “ENGINE START STOP” switch is turned to IGNITION ON mode while the BSM main switch is set to ON.
• When the BSM main switch is set to ON while the “ENGINE START STOP” switch is in IGNITION ON mode.
If the system is functioning correctly, the BSM outside rear view mirror indicators will turn off after a few seconds.
If the BSM outside rear view mirror indicators do not illuminate or do not turn off, there may be a malfunction with the system.
If this occurs, have the vehicle inspected by your Toyota dealer.
*3: The light flashes to indicate that the system is operating.
Warning lights
Warning lights inform the driver of malfunctions in any of the vehicle’s systems. *1: These lights turn on when the engine switch is turned to the “ON” position (vehicles without a smart ...See also:
Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions
only for the maintenance items that are easy to perform. As explained earlier in
this section, several proced ...
Adaptive Highbeam Assist
You can use this function to set the
headlamps to change between low beam and
high beam automatically. The system
recognizes vehicles with their lights on, either
approaching from the opposite ...
To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid ( ...