Chrysler 200: Installing Child Restraint Tether Strap
1. Rotate the cover over the anchor directly behind the seat where you are placing the child restraint.
Installing Child Restraint Tether Strap
1 — Cover
3 — Attaching Strap
A — Tether Strap Hook
B — Tether Anchor
2. Route the tether strap to provide the most direct path for the strap between the anchor and the child seat. If your vehicle is equipped with adjustable rear head restraints, raise the head restraint, and where possible, route the tether strap under the head restraint and between the two posts. If not possible, lower the head restraint and pass the tether strap around the outboard side of the head restraint.
3. Attach the tether strap hook (A) of the child restraint to the anchor (B) and remove slack in the tether strap according to the child restraint manufacturer’s instructions.
An incorrectly anchored tether strap could lead to increased head motion and possible injury to the child. Use only the anchor positions directly behind the child seat to secure a child restraint top tether strap.
Check the fluid level monthly.
1. Drive the vehicle several miles to raise the temperature of the transmission fluid up to normal operating temperature; 158 to 1768F (70 to 808C) is normal. 2. Park the vehicle on a level surface ...
Most common factors contributing to vehicle corrosion
-The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. - Damage to paint and other protective coatings caused by gravel and stone chips or mino ...
Pre-heating or pre-cooling the interior of the vehicle
Models with automatic climate control system: After the system starts the engine, the automatic climate control system will activate the “FULL AUTO” mode and heat or cool the interior to the predet ...