Nissan Altima: Installing top tether strap
First, secure the child restraint with the LATCH lower anchors (rear outboard seat positions only) or the seat belt, as applicable.
1. Flip up the anchor cover 1 from the anchor
point which is located directly behind the
child seat.
2. Position the top tether strap over the top of
the seatback 2 .>
3. Secure the tether strap to the tether anchor
point on the rear parcel shelf 3 .>
4. Refer to the appropriate child restraint installation
procedure steps in this section
before tightening the tether strap.
To remove or reinstall the tether anchor covers, see “Upper tether anchor/key cylinder covers” in the “Maintenance and do-it-yourself” section of this manual.
If you have any questions when installing a top tether strap, consult your NISSAN dealer for details.
Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being p ...Booster seats
...See also:
Tire pressure of at least 180 kPa
(1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa
(1.8 bar/26 psi) has not been achieved:
•► Press the on/off switch on the tire inflation
compressor to 0.
The tire inflation compressor is s ...
Rapid air pressure loss
Rapid air pressure loss or a blow-out can occur if the tire is punctured or is
damaged due to hitting a curb or pothole. Rapid air pressure loss can also be caused
by driving on under-inflated tir ...
Airbag Readiness Light
This light shows if there is an
electrical problem. The system
check includes the airbag sensor(s),
passenger sensing system, the
pretensioners, the airbag modules,
the wiring, and the crash ...