Chrysler 200: Intermittent Wiper System
Use the intermittent wiper system when weather conditions make a single wiping cycle with a variable pause between cycles desirable. Rotate the end of the windshield wiper/washer control lever to the first detent, and then turn the end of the lever to select the desired delay interval. There are five delay settings, which allow you to regulate the wipe interval from a minimum of one cycle every second to a maximum of approximately 18 seconds between cycles.
Changing Intermittent Settings
NOTE:
The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph (16 km/h), delay times will be doubled.
Windshield Wipers And Washers
The wipers and washers are operated by a switch
on the control lever. The lever is located on the
right side of the steering column.
Windshield Wiper/Washer Lever
Rotate the end of the lever ...
Windshield Washers
To use the washer, pull the windshield wiper/washer
control lever toward you and hold it for as long as
washer spray is desired.
If you activate the washer while the wiper control is in
the del ...
See also:
Cruise Control
Cruise Control
The cruise control buttons are located on the steering wheel.
Press to turn the cruise control system on and off. An indicator light will turn on or off in the instrument panel clus ...
Front passenger air bag status
light
The front passenger air bag status light ( )
will be lit and the passenger front air bag will be
OFF depending on how the front passenger seat
is being used.
For front passenger air bag status l ...
Windshield wipers and washers
The wipers and washers are operated by a switchon the control lever. The lever
is located on theright side of the steering column.
Windshield Wiper/Washer
Lever
Rotate the end of the lever t ...