Subaru Legacy: Pre-heating or pre-cooling the interior of the vehicle
Models with automatic climate control system:
After the system starts the engine, the automatic climate control system will activate the “FULL AUTO” mode and heat or cool the interior to the predetermined median (room) temperature. No presetting of controls is necessary.
Models with manual climate control system:
Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the engine, the heater or air conditioning will activate and heat or cool the interior to your setting.
Entering the vehicle following remote engine start shutdown
An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown. ...Service mode
In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced. To engage or disengage service mode: 1. ...See also:
Removing the mechanical key
•► Push release catch 1 in the direction of
the arrow and at the same time, remove
mechanical key 2 from the SmartKey. ...
Brake fluid
For further brake fluid specification information, refer to Capacities and recommended
fuel/lubricants in the Technical and consumer information section of this manual.
WARNING:
- Use only new flu ...
Front fog light switch (if equipped)
The front fog lights operate under the following conditions.
● when the light switch is in the “”
position
● when the light switch is in the “AUTO” position and the headlight ...