Nissan Altima: Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink , continue to press and hold the HomeLink button (see steps 2 - 4 under “Programming HomeLink ”) while you press and repress (“cycle”) your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
When programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.
Programming HomeLink
1. To begin, press and hold the two outer HomeLink buttons (to clear the memory) until the indicator light 1 blinks (after 20 seconds). Release both buttons. 2. Position the end of the hand-held ...Operating the HomeLink universal transceiver
The HomeLink Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed HomeLink Universal Transceiver button. Th ...See also:
Tire rotation recommendations
Tires on the front and rear axles of vehicles operate atdifferent loads and perform
different steering, driving,and braking functions. For these reasons, they wear
atunequal rates.
These effects ...
Odometer
The odometer shows how far the
vehicle has been driven, in either
kilometers or miles.
This vehicle has a tamper-resistant
odometer. If the vehicle needs a
new odometer installed, the new
o ...
Voice command — if equipped
Voice Command can be initiated by pressing the VRbutton
located on the radio or steering wheelcontrols
(if equipped).
Refer to “Voice Command” in the Uconnect™ PhoneUser Manual located on th ...