Buick LaCrosse: Programming the Power
Windows
If the battery on the vehicle has been recharged, disconnected, or is not working, you will need to reprogram each front power window for the express-up feature to work.
Before reprogramming, replace or recharge the vehicle's battery.
To program each front window:
1. With the ignition in ON/RUN or ACC/ACCESSORY, or in Retained Accessory Power (RAP), close all doors.
2. Press and hold the power window switch until the window is fully open.
3. Pull the power window switch up until the window is fully closed.
4. Continue holding the switch up for approximately two seconds after the window is completely closed.
The window is now reprogrammed.
Repeat the process for the other windows.
Rear Window Lockout
Rear Window Lockout
This feature prevents the rear
passenger windows from operating,
except from the driver position.
Press o to activate the rear
window lockout switch. The LED (A)
comes ...
Sun Visors
Sun Visors
Pull the sun visor down to block
glare. Detach the sun visor from the
center mount to pivot to the side
window, or to extend along the rod,
if available. ...
See also:
Automatic Transmission
CAUTION!
Damage to the transmission may occur if the following
precautions are not observed:
• Shift into PARK only after the vehicle has come to
a complete stop.
• Shift into or out of REV ...
Creating Playlists
To create a playlist using tracks
stored in MEM:
1. Select Playlist from the MEM
favorites.
2. Select the track to be stored in
the playlist.
3. Press and hold one of the 1 to 6
buttons unt ...
Power Outlets
The accessory power outlet can be used to plug in electrical equipment, such as a cell phone, an MP3 player, etc.
This outlet is located under the armrest inside the center console storage.
The vehi ...