Subaru Legacy: Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off the fender lining.
Removing air intake duct
Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. Refer to “Type A clips” F11-5. ...Engine hood
To open the hood: 1. If the wiper blades are lifted off the windshield, return them to their original positions. 2. Pull the hood release knob under the instrument panel. 3. Release the secon ...See also:
Floor Mats
The driver’s and right rear
passenger’s floor mats that came
with your vehicle hook over the floor
mat anchors. This keeps the floor
mats from sliding forward and
possibly interfering ...
Locking and unlocking
Central locking
You can only centrally lock the doors ifthey are all closed.
Double locking
WARNINGS:
Do not activate double locking whenpersons or animals are inside thevehicle.
You will not be ...
Telephone commands
Phone
Your phone system allows you to createan additional phonebook. The storedentries can be dialled by voice control.
Phone numbers stored by using voicecontrol are stored on the vehicle systemand ...