Buick Regal: Rear Seats - Seats and Restraints - Buick Regal Owners ManualBuick Regal: Rear Seats

Folding the Seatback

Either side of the seatback can be folded down for more cargo space.

Fold a seatback only when the vehicle is not moving.

Notice: Folding a rear seat with the safety belts still fastened may cause damage to the seat or the safety belts. Always unbuckle the safety belts and return them to their normal stowed position before folding a rear seat.

To fold the seatback down

1. Be sure the safety belt is in the retainer clip.

1. Be sure the safety belt is in the retainer clip.

2. Pull on the lever on the top of the seatback to unlock it.

2. Pull on the lever on the top of the seatback to unlock it.

A tab near the seatback lever raises when the seatback is unlocked.

3. Fold the seatback down.

Repeat Steps 1 through 3 for the other seatback, if desired.

Raising the Seatback

If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there. WARNING
If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there.

Always push and pull on the seatbacks to be sure they are locked.

A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted. WARNING
A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted.

To raise a seatback:

1. Lift the seatback up and push it rearward to lock it in place.

Make sure the safety belt is in the retainer clip and is not twisted or caught in the seatback.

A tab near the seatback lever retracts when the seatback is locked in place.

2. Push and pull the top of the seatback to be sure it is locked into position.
3. Repeat Steps 1 and 2 for the other seatback, if necessary.

When the seat is not in use, it should be kept in the upright, locked position.

Heated Front Seats
WARNING If you cannot feel temperature change or pain to the skin, the seat heater may cause burns even at low temperatures. To reduce the risk of burns, people with such a condition should use ca ...

Rear Seat Pass-Through Door
The vehicle may have a door in the rear seat that provides access to the trunk. Lower the rear seat armrest to access the pass-through door. Pull the release handle to open the door. To close, pus ...

See also:

Engaging reverse gear R
Only shift the automatic transmission to R when the vehicle is stationary. •► When the vehicle is stationary, depress the brake pedal. •► Push the DIRECT SELECT lever up past the ...

UHP Controls
Use the buttons located on the infotainment system and the steering wheel to operate the UHP system. Steering Wheel Controls Steering wheel controls can be used to: • Answer incoming call ...

Hazard warning flasher switch
Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights flash. WARNING ● If stopping for an emergency, be sure to move the v ...