Buick Regal: Removing the Spare Tire and Tools - Tire Changing - Electrical System - Vehicle Care - Buick Regal Owners ManualBuick Regal: Removing the Spare Tire and Tools

To access the spare tire and tools:

1. Open the trunk.
2. Remove the spare tire cover.

3. Turn the retainer nut counterclockwise and remove the spare tire. Place the spare tire next to the tire being changed.

3. Turn the retainer nut counterclockwise and remove the spare tire. Place the spare tire next to the tire being changed.
4. The jack and tools are stored below the spare tire. Remove them from their container and place them near the tire being changed.

    Removing the Flat Tire and Installing the Spare Tire
    Take off the wheel cover or center cap, if the vehicle has one, to reach the wheel bolts. 1. Do a safety check before proceeding. See If a Tire Goes Flat  for more information. 2. Turn the wh ...

    See also:

    Immobilizer (start inhibitor)
    Each of the keys supplied with your vehicle contains a coded transponder. The code in the key is transmitted to an antenna in the ignition slot where it is compared to the code stored in the start ...

    Lights
    Have someone observe the operation of exterior lights while you work the controls. Check turn signal and high beam indicator lights on the instrument panel. ...

    Tire Pressure Light
    For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS. ...