Dodge Avenger: Replacement bulbs - Maintaining your vehicle - Dodge Avenger Owners ManualDodge Avenger: Replacement bulbs

All the inside bulbs are brass or glass wedge base.

Aluminum base bulbs are not approved and should notbe used for replacement.

LIGHT BULBS – Interior Bulb No.

Front Courtesy/Reading Lamp . . . . . . . . . . 578/W5W.

Center Courtesy/Reading Lamp. . . . . . . . . . 578/W5W.

Visor Vanity Lamp. . . . . . . . . . . . . . . . . . . . . . A6220.

Glove Box Lamp . . . . . . . . . . . . . . . . . . . . . . . A6220.

Shift Indicator Lamp . . . . . . . . . . . . . . . . . IKLE14140.

Rear Compartment (Trunk) Lamp . . . . . . . . . . . . . 579.

NOTE: For lighted switches, see your authorized dealerfor replacement.

LIGHT BULBS – Exterior Bulb No.

Low Beam Headlamp . . . . . . . . . . . . . . . . . . . . . H11.

High Beam Headlamp . . . . . . . . . . . . . . . . . . . . 9005.

Front Park/Turn Signal/Side Marker Lamp . . . . 3757A.

Front Fog Lamp . . . . . . . . . . . . . . . . . . . . . . PSX24W.

Center High Mounted Stop(CHMSL) Lamp . . . . . . . . . . . . . . . . . . . W16W (921).

Rear Tail/Stop Lamp . . . . . . . . . . . . . . . . . . . . . 3157.

Rear Turn Signal Lamp. . . . . . . . . . . . . . . . . . . . 3157.

Backup Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . 3157.

License Lamp. . . . . . . . . . . . . . . . . . . . . . . . . . W5W.

Front Position Lamp . . . . . . . . . . . . . . . . . . . . . W5W.

    Vehicle storage
    If you will not be using your vehicle for more than21 days, you may want to take steps to preserve yourbattery. • Disengage the mini-fuse in the Power DistributionCenter labeled IOD (Ignition O ...

    Bulb replacement
    Headlamp 1. Raise the hood and locate the connector behind theheadlamp. NOTE: It may be necessary to remove the air cleanerfilter housing and position the totally integrated powermodule aside prio ...

    See also:

    Selecting preset channels
    Presetting a channel with a preset button allows you to select that channel in a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset. ...

    Tire pressure of at least 180 kPa (1.8 bar/26 psi) is not reached
    If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved: •► Press the on/off switch on the tire inflation compressor to 0. The tire inflation compressor is s ...

    Replacing LATCH System Parts After a Crash
    WARNING! A crash can damage the LATCH system in the vehicle. A damaged LATCH system may not properly secure the child restraint, resulting in serious injury or even death in a crash. To hel ...