Subaru Legacy: Sensor for the auto on/off headlights
The sensor is on the instrument panel as shown in the illustration.
CAUTION
If any object is placed on or near the sensor, the sensor may not detect the level of the ambient light correctly and the auto on/off headlights may not operate properly.
Headlights
To turn on the headlights, turn the knob on the end of the turn signal lever. first position Instrument panel illumination, tail lights, front side marker lights and license plate lights are on ...High/low beam change (dimmer)
To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light “” on the combination meter is also on. To swit ...See also:
Moon roof
Use the overhead switches to open and close the moon roof and tilt
it up and down.
Opening and closing
1 Opens the moon roof*
The moon roof stops slightly
before the fully open position
to ...
Lubrication oil circulation in the refrigerant circuit
Operate the air conditioner compressor at a low engine speed (at idle or low
driving speeds) a few minutes each month during the off-season to circulate its
oil. ...
Heated seats (if so equipped)
The front seats are warmed by built-in heaters.
The switch is located on the center console.
1. Start the engine.
2. Push the LO or HI position of the switch, as desired. The indicator light
in ...