Mercedes-Benz E-Class: Storing settings
With the memory function, you can store up to three different settings, e.g. for three different people.
The following settings are stored as a single memory preset:
- position of the seat, backrest and head
restraint
- active multicontour seat: dynamic function
level
- driver's side: steering wheel position
- driver's side: position of the exterior
mirrors on the driver's and front-passenger
sides
WARNING
Do not activate the memory function while
driving. Activating the memory function while
driving could cause the driver to lose control
of the vehicle.
•► Adjust the seat
•► On the driver's side, adjust the steering wheel and the exterior mirro
•► Press memory button M and one of the storage position buttons 1, 2 or 3 within three seconds.
The settings are stored in the selected preset position. A tone sounds when the settings have been completed.
Memory function
...Calling up a stored setting
•► Press and hold the relevant storage position button 1, 2 or 3 until the seat, steering wheel and exterior mirrors are in the stored position. The setting procedure is interrupted as ...See also:
Compass zone adjustment
Compass calibration zones
1. Refer to the “Compass calibration zones” map shown above to verify that the
compass zone setting is correct for your geographical location.
2. Press and hold the ...
Trip Odometer
The trip odometer can show how far the vehicle has been driven since the trip odometer was last reset.
The trip odometer is accessed and reset through the Driver Information Center (DIC). See Driver ...
Trunk light
The light illuminates when the trunk lid is opened.
When the trunk lid is closed, the light goes off.
The light will go off after about 30 minutes if the trunk lid is left open, unless
the ignitio ...