Buick LaCrosse: System Settings - Operation - Introduction - Infotainment System - Buick LaCrosse Owners ManualBuick LaCrosse: System Settings

Configuring the Number of Favorite Pages

To configure the number of available

To configure the number of available favorite pages:

1. Press the CONFIG button.

2. Select Radio Settings.

3. Select Radio Favorites.

4. Select the number of available favorite pages.

5. Press the go BACK button to go back to the System Configuration menu.

Auto Volume

The auto volume feature automatically adjusts the radio volume to compensate for road and wind noise as the vehicle speeds up or slows down, so that the volume level is consistent.

The level of volume compensation can be selected, or the auto volume feature can be turned off.

1. Press the CONFIG button.

1. Press the CONFIG button.

2. Select Radio Settings.

3. Select Auto Volume.

4. Select the setting.

5. Press the go BACK button to go back to the System Configuration menu.

Maximum Startup Volume

The maximum volume played when the radio with CD is first turned on can be set.

1. Press the CONFIG button.

1. Press the CONFIG button.

2. Select Radio Settings.

3. Select Maximum Startup Volume.

4. Select the setting.

5. Press the go BACK button to go back to the System Configuration menu.

    DSP (Digital Signal Processing) Settings
    For vehicles with DSP, it is used to provide a choice of different listening experiences. The DSP settings for the radio with CD are: • normal - Select this setting to adjust the audio for ...

    Radio
    ...

    See also:

    Certification for the Hands-free system
    NOTE ● This device complies with Part 15 of the FCC Rules and with RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interfere ...

    Steering gear box, linkage & boots/lower arm ball joint
    With the vehicle stopped and engine off, check for excessive free-play in the steering wheel. Check the linkage for bends or damage. Check the dust boots and ball joints for deterioration, cracks, ...

    Reprogramming a Single Universal Remote System Button
    To reprogram any of the three Universal Remote system buttons: 1. Press and hold the desired Universal Remote system button. Do not release the button. 2. The indicator light will begin to ...