Buick LaCrosse: Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
A. Back-Up Lamp
B. Turn Signal Lamp
To replace one of these lamps:
1. Open the trunk. See Trunk.
2. Remove the fasteners and pull back the trunk trim.
3. Remove the four plastic wing nuts holding the taillamp assembly in place.
4. Pull out the taillamp assembly and disconnect the wiring harness.
5. Turn the bulb socket counterclockwise to remove it.
6. Pull the old bulb straight out of the bulb socket.
7. Reverse Steps 1 through 6 to install.
Uplevel Headlamp Assembly
The uplevel model vehicle has a
high intensity discharge (HID) high/low beam, a dedicated DRL, and a
parking/turn signal lamp on the
headlamp assembly. See High
Intensity Discharge (HID) Light ...
License Plate Lamp
The license plate lamps for this
vehicle are on the trunk lid.
To replace one of these bulbs:
1. Open the trunk. See Trunk for more information.
2. Push the end on either of the
lamp assembli ...
See also:
Introduction
The infotainment system's voice control feature1 enables the driver to voice-activate
certain functions in a Bluetooth-connected cell phone or the navigation system.
NOTE
The informati ...
Driving tips
Do not drive with your foot resting on the clutch pedal and do not use the clutch
to hold your vehicle at a standstill on an upgrade. Either of those actions may
cause clutch damage.
Do not drive ...
Active Lane Keeping Assist
Important safety notes
Active Lane Keeping Assist monitors the area
in front of your vehicle by means of a camera
at the top of the windshield. Active Lane
Keeping Assist detects lane markings ...