Buick Regal: Tire and Loading Information Label - Vehicle Load Limits - Driving Information - Driving and Operating - Buick Regal Owners ManualBuick Regal: Tire and Loading Information Label

A vehicle-specific Tire and Loading Information label is attached to the vehicle's center pillar (B-pillar).

A vehicle-specific Tire and Loading Information label is attached to the vehicle's center pillar (B-pillar).

With the driver door open, you will find the label attached below the door lock post.

The Tire and Loading Information label shows the number of occupant seating positions (A), and the maximum vehicle capacity weight (B) in kilograms and pounds.

The Tire and Loading Information label also shows the tire size of the original equipment tires (C) and the recommended cold tire inflation pressures (D). For more information on tires and inflation see Tires  and Tire Pressure .

There is also important loading information on the Certification label. It tells you the Gross Vehicle Weight Rating (GVWR) and the Gross Axle Weight Rating (GAWR) for the front and rear axle. See “Certification Label” later in this section.

    Vehicle Load Limits
    It is very important to know how much weight the vehicle can carry. This weight is called the vehicle capacity weight and includes the weight of all occupants, cargo and all nonfactory-installed optio ...

    Steps for Determining Correct Load Limit
    1. Locate the statement “The combined weight of occupants and cargo should never exceed XXX kg or XXX lbs” on your vehicle's placard. 2. Determine the combined weight of the driver and passengers ...

    See also:

    Center Console Storage
    Center Console Storage The armrest can be adjusted by sliding it to the desired position. The center console has an upper tray and a lower main storage area. To access the main storage area, ...

    Making adjustments in 5 mph (Canada:

    10 km/h) increments
    •► Briefly press the cruise control lever beyond the pressure point, up 1 for a higher speed or down 2 for a lower speed. The last speed stored is increased or reduced. ...

    Scan
    This function plays the first ten seconds of each track/audio file. To start scanning: 1. Press OK/MENU. 2. Turn TUNE to Scan. > The first ten seconds of each track/ audio file will be played. ...