Chrysler 200: Tire Pressures For High Speed Operation - Tire Inflation Pressures - Tires — General Information - Starting and operating - Chrysler 200 Owners ManualChrysler 200: Tire Pressures For High Speed Operation

The manufacturer advocates driving at safe speeds within posted speed limits. Where speed limits or conditions are such that the vehicle can be driven at high speeds, maintaining correct tire inflation pressure is very important. Increased tire pressure and reduced vehicle loading may be required for high-speed vehicle operation.

Refer to original equipment or an authorized tire dealer for recommended safe operating speeds, loading and cold tire inflation pressures.

WARNING!
High speed driving with your vehicle under maximum load is dangerous. The added strain on your tires could cause them to fail. You could have a serious collision. Do not drive a vehicle loaded to the maximum capacity at continuous speeds above 75 mph (120 km/h).

    Tire Inflation Pressures
    The proper cold tire inflation pressure is listed on the driver’s side B-Pillar or rear edge of the driver’s side door. Some vehicles may have Supplemental Tire Pressure Information for veh ...

    Radial-Ply Tires
    WARNING! Combining radial ply tires with other types of tires on your vehicle will cause your vehicle to handle poorly. The instability could cause a collision. Always use radial ply tires in s ...

    See also:

    If the HUD Image Is Not Clear
    • Is the HUD image too bright? • Are the windshield and HUD lens clean? If the HUD image is not correct, contact your dealer. Keep in mind that the windshield is part of the HUD system. ...

    Secondary trunk lid release
    To open the trunk lid from the rear seat: (1) - Fold down the center arm rest. - Insert the mechanical key into the trunk compartment access lid lock. Fold down the trunk compartment access lid. ...

    Side repeater light bulb replacement (if equipped)
    If the light bulb is not operating, have the vehicle checked by an authorized HYUNDAI dealer. ...