Buick LaCrosse: Transferring a Call - Bluetooth (Voice Recognition) - Phone - Infotainment System - Buick LaCrosse Owners ManualBuick LaCrosse: Transferring a Call

Audio can be transferred between the Bluetooth system and the cell phone.

The cell phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the ignition is turned to ON/RUN.

To Transfer Audio from the Bluetooth System to a Cell Phone

During a call with the audio in the vehicle:

1. Press 2. Say “Transfer Call.”.

2. Say “Transfer Call.”

To Transfer Audio to the Bluetooth System from a Cell Phone

During a call with the audio on the cell phone, press transfers to the vehicle. If the audio. The audio transfers to the vehicle. If the audio does not transfer to the vehicle, use the audio transfer feature on the cell phone. See your cell phone manufacturer's user guide for more information.

    Muting a Call
    During a call, all sounds from inside the vehicle can be muted so that the person on the other end of the call cannot hear them. To mute a call, press , and then say “Mute Call.”. To can ...

    Voice Pass-Thru
    Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature. To access cont ...

    See also:

    Steering gear box, linkage & boots/lower arm ball joint
    With the vehicle stopped and engine off, check for excessive free-play in the steering wheel. Check the linkage for bends or damage. Check the dust boots and ball joints for deterioration, cracks, ...

    Making adjustments in 1 mph (Canada:

    1 km/h) increments
    •► Briefly press the cruise control lever to the pressure point, up 1 for a higher speed or down 2 for a lower speed. The last speed stored is increased or reduced. ...

    Scan
    This function plays the first ten seconds of each track/audio file. To start scanning: 1. Press OK/MENU. 2. Turn TUNE to Scan. > The first ten seconds of each track/ audio file will be played. ...