Subaru Legacy: Upshift/downshift indicator (AT and CVT models)
When the manual mode is selected, the gear position indicator (which shows the current gear selection) and the upshift/ downshift indicator light up. Refer to “Automatic transmission/Continuously variable transmission” F7-18.
Select lever/gear position indicator
1) Upshift/downshift indicator (AT and CVT models) This indicator shows the position of the shift lever (MT models) or select lever (AT and CVT models). ...Gear position indicator setting (MT models)
The gear position indicator light can be activated or deactivated by performing the following procedure. 1. Turn the ignition switch to the “LOCK” position. 2. Press the trip knob to show “ ...See also:
Automatic deactivation
In certain situations, the Automatic Engine Start/
Stop Function is deactivated automatically for
safety reasons, such as when the driver is detected
to be absent
Malfunction
The automatic eng ...
Wheel balance
Each wheel was correctly balanced when your vehicle was new, but the wheels will
become unbalanced as the tires become worn during use. Wheel imbalance causes the
steering wheel to vibrate slightl ...
Using the telephone - Vehicles Without: Navigation System
This chapter describes the phonefunctions of the audio unit.
Note: Refer to your audio guide fordetails of the controls.
An active phone must be present.
Even if connected to the audio unit, yourph ...