Buick Regal: Using the Dial Command - Bluetooth (Voice Recognition) - Phone - Infotainment System - Buick Regal Owners ManualBuick Regal: Using the Dial Command

1. Press ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone..

► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.

► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.

2. Say “Dial.” The system responds “Dial using <phone name>.

Number please,” followed by a tone.

3. Say the entire number without pausing.

► If the system recognizes the number, it responds with “OK, Dialing” and dials the number.

► If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say “Yes.” The system responds “OK, Dialing” and dials the number. If the number is not correct, say “No.” The system will ask for the number again.

    Making a Call
    Calls can be made using the following commands: ► Dial ► Digit Dial ► Call ► Re-dial ...

    Using the Digit Dial Command
    1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. Aft ...

    See also:

    When reading the manual
    This manual includes information for all options available on this model. Therefore, you may find some information that does not apply to your vehicle. All information, specifications and illustrat ...

    Jack Location
    The jack and jack-handle are stowed under the load floor in the trunk. ...

    General information
    Location of the side impact (SIPS) airbags (front seats only) As an enhancement to the structural side impact protection built into your vehicle, it is also equipped with Side Impact Protection S ...